99
2013-03-30 20:41:13
0
Usually it is not necessary to apply greese on the bolts and connectors, in any case "No-oxide" grease increase the protection against corrosion.
대게 볼트와 커넥터(연결하는 무언가..?선아니면 어떤 특정 물체)에 기름칠을 하지 않습니다. 산소가 접촉되지 않은 기름이 부식을 막아주고 보호력을 높이기 때문이죠.
It is recommended therefore, that voltage regulation across the system including the load, but without the B connected, under steady state conditions, shall be better than ± 1 through 5% to l00% load. Transient and other ripple type excursions can be accommodated provided that, with the B disconnected but the load connected, the system peak to peak voltage, including the regulation limits, falls within 2.5% of the recommended float voltage of the B..Under no circumstances should the current flowing through the B when it is operating under float conditions, reverse into the discharge mode.
이와같이, (B를 연결하지 않은 채) 가지고있는 장비 사용 시스템을 유지하면서 볼트 사용하는 것이 5~100%를 로딩하는 것 보다 좋습니다(+/1 오차). 일시적이고 짧은 물결 타입의 여정들이 ............ 죄송... 무슨말인지 잘 모르겠어여 ㅜㅜ